Is this Safe to use? - Beyond the Manual - Glowforge Owners Forum

I have read this page several times and I am unable to determine if it is a Good/Safe tape for the Glowforge. I was looking for something that would stick to MDF and Plywood. I have some masking Tape but as soon as the laser cuts around it the tape comes loose. I have also read the Threads on Masking Tape and it seems there was no conclusion on which was the best.

Needed : an interface from Glowforge to Filter - Beyond the Manual

Non-Proofgrade Cutting Help! - Beyond the Manual - Glowforge

Stippling/poor texture during light engraves - Beyond the Manual

Semi Precious Stones - Beyond the Manual - Glowforge Owners Forum

Glowforge Quickie, Leatherette Patch, Glowforge Project

Why an egg? Because it can - Beyond the Manual - Glowforge Owners

Replacing the Air Assist fan - wiring question - Beyond the Manual

Cant get past warning for unidentified material screen - Beyond

Marking Success on 1/8 Stainless Steel and 3D Engrave Questions

Control panel material? - Beyond the Manual - Glowforge Owners Forum