Hello, I read lots of posts regarding Circles not round and do not meet but couldn’t see the same issue I experience. I am new to laser cutting and just assembled a Sculpfun S30 Pro (10W) with Y axis extension. When engraving / cutting the first test pattern, the cut circles are oval and there are strange lines off the circles (and rectangles too). I run some additional tests just on the cutting after adjusting the Y axis belt, but it made no difference. I then used LaserGRBL to make t
Circle trouble - beginning and end are offset - LightBurn Hardware Compatibility - LightBurn Software Forum
Change Vendorsettings with Lightburn - Ruida controllers - LightBurn Software Forum
Offset issue..offset of a circle isn't round - LightBurn Software Questions - LightBurn Software Forum
Circle trouble - beginning and end are offset - LightBurn Hardware Compatibility - LightBurn Software Forum
Circle trouble - beginning and end are offset - LightBurn Hardware
Offset issue on only one axis? - GRBL - LightBurn Software Forum
SM1 Laser (1600 mW) and working with Lightburn - Getting Started - Snapmaker: where creation happens
New upload 1.2.04, Offset Fill problem - LightBurn Software Questions - LightBurn Software Forum
Circle trouble - beginning and end are offset - LightBurn Hardware Compatibility - LightBurn Software Forum